Process Data Sheet
EOS NickelAlloy HX for EOS M 290 | 40 µm
EOS M 290 - 40 µm - TRL 9
| System Setup | EOS M 290 |
|---|---|
| EOS Material set | HX_040_PerformanceM291 |
| Software Requirements |
EOSPRINT 2.5 or newer |
| Recoater Blade | HSS (High Speed Steel) |
| Nozzle | EOS Grid Nozzle |
| Inert gas | Argon |
| Sieve | 63 µm |
| Additional Information | |
|---|---|
| Layer Thickness | 40 µm |
| Volume Rate | 4.2 mm³/s |
| Min. Wall Thickness | Typical 0.3 - 0.4 mm |
Microstructure of the Produced Parts
| Defects | Thickness | Result | Number of Samples |
|---|---|---|---|
| Average Defect Percentage | 40 µm | 0.04 % | - |
| Density EN ISO 3369 | Thickness | Result | Number of Samples |
|---|---|---|---|
| Average Density | 40 µm | ≥ 8.2 g/cm³ | - |
Mechanical Properties
Mechanical Properties As Manufactured
| EN ISO 6892-1 Room Temperature | 40 µm | Yield Strength [MPa] | Tensile Strength [MPa] | Elongation at Break A [%] | Reduction of Area Z [%] | Modulus of elasticity [GPa] | Number of Samples |
|---|---|---|---|---|---|---|
| Vertical | 550 | 680 | 39 | - | - | - |
| Horizontal | 630 | 820 | 27 | - | - | - |